WARNING!! -This is a really fun one and could possibly get addictive!
You will/may need:
Knitting wool – double knitting and above in thickness, and lots of colours!
Crochet hook or knitting needles,
Fabric for patchworking,
Webbing and webbing stretcher if there is not ‘seat’,
Hessian or similar fabric for underside of seat.
This is a great way to recycle an old chair you/friend may have or that you’ve found down a charity shop. Firstly, you need to clean your chair and tighten up any nut and bolts. If your seat has wicker for the ‘seat’, strip this as close to the wood as possible.
If you have a wooden seat, check there’s no nails etc sticking out, which could be dangerous. If you have a seat which was a woven wicker, which you have now stripped, then you will need to ‘web’ a seat – YouTube has many sites explaining this method.
You are now ready for the fun stuff! Using either crochet or knitting, make narrow strips according to a rough estimate of the width and length of you chair. I started with the legs. I calculated roughly by first crocheting a chain which I wrapped around the base of the leg and worked in treble crochet, making brightly coloured stripes.
When I had reached a ‘joint’ in the chair, I would slightly decrease the number of stitches to work around the joint, then increase again after. (When two joints meet the crocheted sections will be sewn together to cover the join.)
Once, the crocheted length was the correct size, I would cast off, then sew the section to around the leg of the chair, pulling tight to ensure the wool stitching is discreetly disguised.
Continue working this way, making lengths of crochet to wrap around the different joints of the chair.
If you have webbed the seat, stitch the lengths of crochet through the webbing. If you have a wooden seat, using small tacks, nail the crochet length around the base of the seat, ensuring your tacks will be covered over with your seat pad later. Also, ensure all tacks are safely hammered in.
Once your chair is fully yarn bombed, you will now need a foam seat pad which you can either buy pre-cut from a shop. Then, you will need to decide how to cover it. I choose to cover my seats using my daughter’s skirts and trousers they had grown out of. These were in great fabrics – ideal for upholstery – such as cord, velvets and denims. I decided to cut them and sew them into ‘crazy patchwork’. This is a traditional technique, which uses up small pieces of fabric. But, you could choose to continue with the crochet/knitting and make a cover or use a full piece of fabric to cover the cushion pad.
The fabric, with the pad positioned underneath, was tacked around about 1cm from the top edge of the seat. I then, made a crochet binding to cover the tacked edge, by crocheting a long length in two rows of double crochet. This was then discreetly sewn onto the patchwork and the chair.
You’re now almost finished! To make your chair look neat and tidy, it’s always best to cover your working, so that there’s no little wool ‘tails’ dangling from your chair. I would, therefore, recommend to now cover the underside of the seat with hessian to hide your working. This can be done with a small square of hessian, or another fabric you have at hand, and tack that to the underside of the seat.
Now, you can enjoy your most gorgeous and fabulous seat – invite your friends round and maybe make another!